Parameter Setup Menues; Operationparameter - Wilo Cc-System Einbau- Und Betriebsanleitung

Menue Display
-No.
visible for
User 1 and higher:
Call User 2 and higher:
by: Service:
3.3

Parameter setup menues

3.3.1 Operation mode site
3.3.2

Operationparameter

3.3.2.1 1. Set point
Installation and operating instructions Wilo-CC-System
Description
*
**
***
* (page 3 - Station name)
Input of station name and PIN-
number of SIM-card for telem-
etry
* (Page 4 – SMS-target phone
numbers)
Input of maximum 4 phone-
numbers (1-4) and the pro-
vider's number (SMS-Centers)
(phonenumber 5); Choosing by
the softkeys +/-
* (Page 1)
Call of the menues operation-
mode site, operation parame-
ters and controllerparameters
* (Page 2)
Call of menues for pumppa-
rameters, FC-Parameters and
FC-Status
* (Page 3)
Call of menues for clock, dis-
playsettings and SMS-adjust-
ments
* Fixing of the operationmode of
the site (Automatic with/with-
out FC), Switching on and off of
all drives
* Call of menues for setpoint and
limit values, sensorsettings
* Setting of 1. setpoint (base
setpoint)
Parameter settings/
Functions
changeable by
User 1 and higher: *
User 2 and higher: **
Service: ***
Station name **
[txt, 16 chars]
PIN [num., 4 digits] **
Phone number 1-5 **
[num., 16 digits]
none
none
none
Operation mode site **
none
p [bar] **
Set1
t [s] **
TLS
English
Factory-
settings
„WILO CC
System"
Installation
specific
Installation
specific
-
-
-
Drives off
-
Installation
specific
180
35