Gewiss GW 10 766 Bedienungsanleitung Seite 22

PROGR MMING WITH THE E SY CONTROLLER
After creating the required function the actuator's operating parameters can be set.
The parameters available, in relation to the function created, are listed in the following
table.
The underlined value is the default value.
Function: timer mode
Parameter: activation time
not active
1 second
2 seconds
3 seconds
5 seconds
10 seconds
15 seconds
20 seconds
30 seconds
45 seconds
1 minute
1.25 minutes
1.5 minutes
2 minutes
2.5 minutes
3 minutes
5 minutes
15 minutes
20 minutes
30 minutes
1 hour
2 hours
3 hours
5 hours
12 hours
24 hours
Configuration parameters (Easy)
no timing
relay activated for 1 second
relay activated for 2 seconds
relay activated for 3 seconds
relay activated for 5 seconds
relay activated for 10 seconds
relay activated for 15 seconds
relay activated for 20 seconds
relay activated for 30 seconds
relay activated for 45 seconds
relay activated for 1 minute
relay activated for 75 seconds
relay activated for 1.5 minutes
relay activated for 2 minutes
relay activated for 2.5 minutes
relay activated for 3 minutes
relay activated for 5 minutes
relay activated for 15 minutes
relay activated for 20 minutes
relay activated for 30 minutes
relay activated for 1 hour
relay activated for 2 hours
relay activated for 3 hours
relay activated for 5 hours
relay activated for 12 hours
relay activated for 24 hours
22