Programming With The Easy Controller - Gewiss GW 10 766 Bedienungsanleitung

PROGR MMING WITH THE E SY CONTROLLER
Programming the actuator through the Easy base unit (code GW 90 831) or with Easy
Controller (GW 90 837 / GW 90 838 / GW 90 840).
The actuator channel to be used in the function that is to be created can be selected at
choice:
• by pressing the local command button: the corresponding channel will be highlighted
in the channel list;
• directly from the list of channels.
The functions can be created after the devices have been selected.
Names of the functions
buttons
edges
timer mode
priority control
scene
Refer to the Easy base unit or the Easy Controller documentation for further information
on the programming procedures.
Load activation or deactivation
Load activation or deactivation
Load activation with timer
Activation of priority controls
Activation of the scenes
21
E
N
G
L
I
S
H