Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
PNEUMATIC CONNECTION
The PULSTRONIC range comprises the following 4 main versions:
- D N 0 . 5 : w i t h i n s t a n t f i t t i n g s
- DN4 - DN7 - DN12mm: with threaded connections
DN 0.5mm
Version
DN 0.5
DN 4
DN 7
DN 12
(
) On request, these versions can be equipped with a connection flange with threaded port 3 (size identical to port 1) for exhaust
*
collection or silencer mounting.
C O D E S
Silencers
Plastic body
34600406
G1/8
34600407
G1/4
34600409
G1/2
Recommendations for pneumatic connection
To achieve tightness, use a cylindric fitting with fitting sealing disc or a tapered fitting and a liquid sealant. Make sure to apply only a
small quantity of sealant.
PTFE (polytetrafluoroethylene) sealing tape and hemp should not be used as they may get into the inside of the valve and damage it.
To ensure maximum performance, we recommend using pneumatic lines and connections adjusted to the nominal diameter of the valve.
The supply pressure must always be less than the maximum input pressure and must be 0.5 bar above the maximum output
pressure.
Use a sufficiently filtered pressure supply (50 µm, free of condensate). Mount the filter as close as possible to the PULSTRONIC valve.
OPERATING PRINCIPLE
Analog setpoint
Analog feedback
3
1
(Pressure supply)
Instant fittings for flexible hose Ø4mm O.D.
G1/8
G1/4
G1/2
Bronze body
34600001
34600002
34600004
DN 0.5 mm
1
2
DN 4 - DN 7 - DN 12 mm
Port connections
2
(Pressure outlet)
G1/8
G1/4
G1/2
G1/8 - G1/4 - G1/2
Analog setpoint
Analog feedback
2
PULSTRONIC
Port 3 threaded on request.
3
3
(Exhaust)
protected, not connectable
protected, not connectable(
protected, not connectable(
protected, not connectable(
1
3
or/ou/oder
3
)
*
)
*
)
*
5
Werbung
Kapitel
