joucomatic PULSTRONIC 605 series Bedienungsanleitung Seite 3

Series 605
GENERAL
The PULSTRONIC is a compact electropneumatic pressure regulator (E/P transducer)
which converts an electrical signal into a pneumatic pressure. It is particularly suited for precise
pressure regulation due to its integrated control loop with electronic pressure feedback.
SPECIFICATIONS
FLUID
CONNECTION
OPERATING PRESSURE
TEMPERATURE - FLUID
- AMBIENT :0 °C to 50 °C
ANALOG SETPOINT
FAILSAFE FUNCTION
HYSTERESIS
REPEATABILITY
CONSTRUCTION
Body: aluminium and synthetic material
Internal parts: stainless steel and synthetic material
Sealings: nitrile (NBR), FPM
ELECTRICAL CHARACTERISTICS
Voltage
Max. consumption
(residual ripple: max.10 %)
+/-10%
24 V=
CHOICE OF EQUIPMENT
Ø
Ports
Instant fitting O.D. 4 mm
G 1/8
G 1/4
G 1/2
CODIFICATION
A: CONSTRUCTION (connection), body
1 = DN 12, 1/2, indirectly operated
5 = DN 0.5, i n s t a n t f i t t i n g f o r f l e x i b l e h o s e O . D . 4 , d i r e c t l y o p e r a t e d
7 = DN 4, 1/8, indirectly operated
9 = DN 7, 1/4, indirectly operated
S: SETPOINT
0 = 0 ... 10 Volt
1 = 0 ... 20 mA
2 = 4 ... 20 mA
O: OPTION (
0 - without option
1 = Feedback output 0 ... 10 Volt
2 = PNP pressure switch, ± 5 %
( )Only one option possible.
*
Special designs (consult us).
Versions in bold letters are standard versions.
ACCESSORIES
• Fastening clips for adaptation on symmetrical rails to DIN/EN 50022, set of 10 clips - cat. no: 33400036 (only for DN 0.5 version)
• Spade plug, 4 to 6 diameter cable, size 15 connector, DIN 43650, 9,4 mm, industry standard B - IP65, with 4 pins - cat. no.: 88100240
3-PORT PROPORTIONAL VALVE
WITH CONTROL LOOP
PULSTRONIC
:air or neutral gases, filtered at 50 µm, lubricated or not
:instant fittings for flexible hose O.D. 4 mm
G 1/8, G 1/4, G 1/2
:see "pressure range"
:0 °C to 60 °C
:0 - 10 V, 0 - 20 mA, 4 - 20 mA
:pressure held at power failure, without control
:< 1 % of maximum output pressure (PMR)
:0.5 % of maximum output pressure (PMR)
Max. current
(W) (mA)
150
3 . 6
Ø Nominal diameter
6 0 5
)
*
W
X
3
Protection
Insulation
degree
class
F
IP 65
(mm)
0 . 5
4
7
12
A S O F P
P: PRESSURE RANGE
Relative pressure:
1 = 0 - 1 bar (only on DN 0.5)
2 = 0 - 2 bar
3 = 0 - 3 bar
6 = 0 - 6 bar
0 = 0 - 10 bar
F: PNEUMATIC CONNECTION
(tapped port 1 - 2 (3))
0 = tapped G (ISO 228/1),
exhaust (3) protected, non connectable
3 = tapped G (ISO 228/1),
with collectable exhaust (3) (
4 = tapped NPT, exhaust (3) protected, non connectable
( )
* *
5 = tapped NPT, with collectable exhaust (3) (
( )Selectable for DN4, 7, 12 only.
* *
For DN0.5 : F=0
Pulstronic DN 0.5 Pulstronic DN4...DN12
W
X
1
2
2
Electrical connection
Spade plug size 15 connector, DIN 43650,
9,4 mm, industry standard B, rotatable by 90°
(delivered with solenoid valve)
Flow at 6 bar
(l/min - ANR)
7
550
1250
4000
Min.-max. input pressure:
1.5 - 2 bar
2.5 - 5 bar
3.5 - 5 bar
6.5 - 8 bar
10.5 - 12 bar
)
* *
GB
1
3
)
* *
3