Storage And Maintenance; Environmental Protection - Stiga BIO MASTER 2200 Gebrauchsanweisung

Disconnect the extension lead (5) BEFORE the general
mains socket (7) THEN from the machine plug (6).
Remove and empty the bag.

4. STORAGE AND MAINTENANCE

IMPORTANT Routine and accurate maintenance is essen-
tial in maintaining original machine safety and performance
levels.
Store the machine in a dry place.
Disconnect the machine from the mains power supply
before starting any cleaning, inspection or maintenance
activities.
IMPORTANT Only the work described in this manual may be
performed by the user, all other work must be performed by
an authorized service centre.
1) Wear sturdy work gloves before cleaning, maintaining
or adjusting the machine.
2) After each use, remove the collection box and clean
the remaining debris in the discharge chute.
3) Always make sure the air vents are free of debris.
4) Do not spray water onto and avoid wetting the motor
and electrical components. Do not use harsh liquids to
clean plastic parts.
Do not ever try to perform complicated repair work;
5)
work that is not described in this manual must be
performed by an authorized service centre. Any work,
except that which is described in this manual, which
is not performed by an authorized service centre will
void the Warranty and will exclude the manufacturer
from liability.

5. ENVIRONMENTAL PROTECTION

Environmental protection should be a priority of considera-
ble importance when using the machine, for the benefit of
both society and the environment in which we live.
– Avoid causing any disturbance to the surrounding area.
– Scrupulously comply with local regulations for the disposal
of waste materials after working.
– Scrupulously comply with local regulations for the dis-
posal of packaging, deteriorated parts or any elements with
a strong environmental impact; this waste must not be dis-
posed of as normal waste, but must be separated and taken
to specified waste disposal centres where the material will
be recycled.
– When decommissioning, do not abandon the machine in
the environment, but hand it over to a disposal centre, in
accordance with the local regulations in force.
6. DIAGNOSTICS
What to do when ...
Source of problem
1. The machine does not work
Electric current does not reach
the machine
2. Machine start up initiates the automatic general power supply
The capacity (in amps) of the
line that feeds the mains power
socket is insufficient
Other electrical appliances are
working
3. The machine stops during work
The protection device triggers
4. The machine stops frequently during work or it does not
operate in a regular manner
Demanding working conditions
Clog in the feeding hopper
The cutting blade is dull
The grass-catcher is clogged
5. Poor and unsatisfactory performance levels
The cutting blade is dull
For any doubts or problems, please do not hesitate to con-
tact your nearest Customer Service Centre or Your Dealer.
5
Corrective action
Check the electrical connection
switch
Connect the machine to a mains
power socket with enough am-
perage to power the line
Do not connect other equipment
to the same power line at the
same time
Wait at least 5 minutes before
restarting the motor
Chip softer material
- Empty the bag
- Remove the feeding hopper
(see paragraph 3.5)
Take the machine to the author-
ized service centre for replace-
ment of the blade
Empty the grass-catcher regularly
before it fills completely
Take the machine to the author-
ized service centre for replace-
ment of the blade