Intended Use; Safety Information; Disposal Information - Bosch BSG7-Serie Gebrauchsanweisung

en
Please keep this instruction manual.
When passing the vacuum cleaner on to a third party,
please also pass on this instruction manual.

Intended use

This vacuum cleaner is intended for domestic use only, not
for commercial use.
Only use this vacuum cleaner in accordance with the
instructions in this instruction manual.
The manufacturer will not accept any responsibility for
damage caused by improper use or incorrect operation.
Therefore, please note the following points.
The vacuum cleaner must only be operated with:
Manufacturer's original
MEGAfilt ® SuperTEX dust bags
Manufacturer's original replacement parts, accessories
and optional accessories
The vacuum cleaner is not to be used for:
vacuuming persons or animals
vacuuming up:
– Insects and spiders
– Hazardous, sharp-edged, hot or burning substances.
– Damp or liquid substances
– Highly flammable or explosive substances and gases
– Ash, soot from tiled stoves and central heating
systems

Safety information

This vacuum cleaner complies with the recognised rules of
technology and the relevant safety regulations.
We confirm that it complies with the following European
directives: 89/336/EEC (amended by Directives
91/263/EEC, 92/31/EEC and 93/68/EEC). 73/23/EEC
(amended by Directive 93/68/EEC).
Always observe the information on the rating plate when
using the vacuum cleaner and connecting to the power
supply.
Never use the vacuum cleaner without a
MEGAfilt ® SuperTEX dust bag.
=> This can damage the vacuum cleaner.
Only allow children to use the vacuum cleaner under
supervision.
Keep suction away from your face when using the
handle, nozzles or pipe.
=> This could cause injury!
Never carry the vacuum cleaner by the power cord.
Fully extend the power cord when using the vacuum
cleaner continuously for several hours.
When disconnecting the vacuum cleaner from the mains,
pull the plug, not the power cord.
Do not pull the power cord around sharp corners or allow
it to become trapped.
Unplug the power cord from the mains before carrying
out any work on the vacuum cleaner or its accessories.
Do not use the vacuum cleaner if it is damaged. Unplug
the power cord from the mains if a fault is detected.
10
For safety reasons, only authorised after-sales service
personnel are permitted to carry out repairs and fit
replacement parts to the vacuum cleaner.
The vacuum cleaner should be protected from outside
weather conditions, moisture and sources of heat.
The vacuum cleaner is not suitable for use on building
sites.
=> Vacuuming up building rubble could damage the
vacuum cleaner.
Switch off the vacuum cleaner when it is not in use.
At the end of its life, the vacuum cleaner should be
disposed of in an appropriate manner.
For safety reasons, vacuum cleaners with a power rating
of more than 2000 W are fitted with a temperature safety
switch.
This automatically switches off the vacuum cleaner if it is
blocked and overheating.
Unplug the power cord from the mains and make sure
that the nozzle, suction pipe and hose are not blocked.
Also check whether the filter needs changing.
Having cleared the blockage, leave the vacuum cleaner
to cool down for at least one hour. It can then be
switched back on again.

Disposal information

Packaging
The packaging is designed to protect the vacuum cleaner
from being damaged during transportation.
It is made of environmentally-friendly materials and can
be recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many recyclable
materials.
Therefore, please take used vacuum cleaners/used
exhaust filter change indicators to your retailer or
recycling centre so that they can be recycled. For current
disposal methods, please enquire at your appliance
dealership or local council.
!
Please note
The mains socket must be protected by a 16 amp fuse
minimum.
If a circuit breaker should trip when you switch on the
vacuum cleaner, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from tripping, select the lowest
power setting before switching the vacuum cleaner on,
and increase the power only once it is running.