Machine Description; Delivery Contents - Kity MST254 Originalbetriebsanleitung

1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Strasse 69
D-89335 Ichenhausen
Dear Customer,
We hope you enjoy working with your new machine
and we wish you every success.
Note:
According to the applicable Product Liability Law, the
manufacturer of this device is not liable for injury to
persons or damage caused to or by this device in the
event of:
• improper handling,
• non-compliance with the operating instructions,
• repairs by third parties who are not authorised
specialists,
• installation and replacement of non-original spare
parts,
• use other than for the intended purpose,
• failure of the electrical equipment in the event of
non-compliance with electrical instructions and
VDE Specifications 0100, DIN 57113 / VDE 0113.
Please note:
Before assembling and commissioning the device,
read the entire user manual.
This user manual is designed to make it easier for
you to get to know your machine and to use it for its
intended purpose.
The user manual contains important information
about how you can work with the machine in a safe,
professional and economic way, how you can prevent
hazards, save money on repairs, reduce downtimes
and increase the reliability and durability of the ma-
chine.
In addition to the safety instructions in this user man-
ual, you must also, without fail, observe the regula-
tions relevant to your country for the operation of this
machine.
Store the user manual in a plastic cover close to the
machine, protected from dirt and moisture. It must
be read and followed carefully by every user before
working with the machine. Only those who have been
instructed in the machine's use and taught about as-
sociated hazards, may use it. The minimum age re-
quirement must be complied with.
In addition to the safety notices contained in this op-
erating manual and the particular instructions for your
country, the generally recognised technical regula-
tions for the operation of identical devices must be
complied with.
22 І 52

2. Machine description

1. Rip fence
2. Unlocking button
3. On/off switch for table operation
4. Upper saw table
5. Handle
6. Saw-shaft lock
7. Motor
8. Extension fence
9. Lower saw table
10. Dial
11. Lower saw table
12. Saw blade
13. Locking button
14. Lower saw blade cover
15. Work piece holder
16. Mitre lock
17. Saw blade guard, moveable
18. Lock screw
19. Wood chip collection bag
20. Lock pin
21. Set screw
22. On/off switch for chopping operation
23. Cross stop
24. Star knob screws
25. Star knob screw
26. Indicator
27. Dial
28. Push stick
29. Allen key 6 mm
30. Allen key 3 mm
31. Foot
32. Allen screw
33. Rubber foot
34. Nut
35. Screw
36. Fixing nut
37. Upper saw blade guard
38. Riving knife
39. Extension fence
40. Allen screw
41. Lock nut
42. Angle indicator
43. Indicator
44. Allen screw
45. Lock nut
46. Dust extraction nozzle
47. Screws (saw blade guard)
48. Screws (upper saw table)
49. Screws (lower saw table)
50. Flange screw
51. Outside flange
52. Inside flange
53. Moveable stop rail

3. Delivery contents

1 x table/chop/mitre saw
1 x carbide tipped saw blade
1 x Allen key 6 mm
1 x Allen key 3 mm
1 x rip fence
1 x cross stop
1 x push stick
• Open the packaging and carefully remove the ma-
chine.
• Remove packaging and transportation safety de-