Product Overview - Renkforce 1884853 Bedienungsanleitung

Product overview

1 2 3
7
1 POWER LED
2 LED indicators for the connections (26x)
3 RJ45 connections 1 to 24 (not shown individually)
4 SFP ports 1 and 2
5 Double-sided threaded holes for mounting bracket (not illustrated)
6 Cold-device socket
7 Ventilation openings (on rear side and both sides, not illustrated)
Setup and installation
Before mounting the product, remove all connected devices and unplug the power adapter from
the cold-device socket (6) on the gigabit switch.
a) Installation
You can use the feet to place the gigabit switch on a horizontal, heat-resistant surface. Follow
the steps below to place the device on a level surface.
• Pull the feet off the protective strips and stick them symmetrically to the bottom of the product
(surface of the truncated pyramid). Place the feet on the four corners so that the device will
not wobble.
• When setting up the product, ensure that there is enough space around the sides to ensure
that air can circulate and cool the device.
b) Mounting in a 19" server rack
You use the mounting bracket to mount the gigabit switch in a standard 19" server rack. Follow
the steps below to mount the switch:
• Use the screws provided to secure the mounting bracket to the threaded holes (5) on the
housing.
• Mount the gigabit switch into the rack with the server rack screws (not included).
Ensure that there is a mains socket near to where the switch is mounted so that you
can plug in the mains cable.
3 3 4 4
6
7
Setup
a) Data connections
• Connect the desired network devices to the RJ45 connections (3).
5
• You can connect up to 24 network devices using the RJ45 connections and cables. The
network cable can be up to 100 m long.
b) Mains connection
• Connect the cold-device socket (6) on the product to a standard mains socket using the
mains cable provided.
• The POWER LED (1) will turn on to indicate that the gigabit switch is supplied with electricity.
c) LED indicators
LED name Colour
Power Green
Link/Act Green
1000M Green
SFP Green
Care and cleaning
• This product does not require maintenance. This product does not contain any components
that require maintenance. Never attempt to open it.
• Always disconnect the product from the power supply before cleaning it.
• Disconnect all cables from the product before cleaning.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may
damage the housing or cause the product to malfunction.
• Use a dry, lint-free cloth to clean the product. Do not press too hard on the housing, as this
can lead to scratch marks.
Disposal
Electronic devices are recyclable waste and must not be placed in household
waste. At the end of its service life, dispose of the product according to the relevant
statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
State Meaning
On Power supply on
Off Power supply off
On Network connected
off Network disconnected
Flashing Data transfer (send/receive)
On A 1000 MBit/s device is connected to this
connection
Off A 10/100 MBit/s device is connected to this
connection, or there is no network device
connected.
On A device is connected to the socket.
Off There is no device connected to the socket
Flashing Data transfer (send/receive)