Programming The Timer - Stöckli Steamer Program Anleitung

Programming the timer

Use the timer to set an LUK [PTL for the appliance to switch off automatically.
([[LU[PVU!
,_HTWSL
Mode change
2 sec.
Enter a value
Mode change
Enter a value
Display
Deleting the
timer
programming
0M H Z[LHTPUN [PTL PU L_JLZZ VM  TPUZ H[ M\SS WV^LY PZ PU[LUKLK
TVYL SPX\PK T\Z[ IL HKKLK
([ OHSM WV^LY H Z[LHTPUN [PTL VM  TPUZ PZ WVZZPISL ^P[OV\[ [OL
ULLK [V HKK TVYL SPX\PK
;OL J\YYLU[ [PTL PZ  (4 ;OL ]LNL[HISLZ OH]L H Z[LHTPUN [PTL
VM  TPUZ HUK ZOV\SK IL YLHK` H[  UVVU
Press both buttons simultaneously for two seconds.
Four signal dots light up, indicating timer programming mode operation.
If no value is entered, the appliance automatically switches to steaming
time mode after approx. 20 seconds. If the dots disappear, switch back
to timer programming as described below under «Mode change».
Press the button to enter
This corresponds to the remaining time of 2 hours and 30 minutes
between 9.30 AM and 12 noon.
Press both buttons simultaneously to switch to steaming time mode.
No dots light up.
Press the button to enter
This represents a steaming time of 30 minutes.
Once the value has been entered, no confirmation is necessary. After a
few seconds, the display automatically changes to represent active app-
liance mode. The timer function dots flash. The number on the display
starts to count back.
At 11:30 am, the steamer mode switches and steaming starts automati-
cally. The running light appears on the display.
To delete the timer programming value.
Q
Disconnect the mains cable
Q
Press the button, until the standby display
.
.
is shown.
39