Parts And Their Functions - Panasonic AG-MYA30G Bedienungsanleitung

Parts and their functions

3
4 6
1Level control
Turn one or both of these controls to
adjust the input level of the sound.
The input levels of the CH1 (left
channel) and CH2 (right channel)
sound can be adjusted separately.
Normally, it is recommended that the
controls be kept at the center position.
Minimum
Maximum
E-7
5 1
2
OOnce the unit is mounted on the AG-
HMC40P, AG-HMC41E, AG-DVC30 or
AG-DVC32, the audio levels of the mic
input signals can no longer be adjusted
using the controls on the camera-
recorder.
2XLR connectors (INPUT1, INPUT2)
Connect a microphone or audio unit
here.
3MIC/LINE switch
Set the switch
corresponding to the unit connected to
the XLR connector (INPUT1 or INPUT2).
LINE:
Set the switch to LINE when an
audio unit has been connected to
the XLR connector.
The input level is 0 dBu.
At this point, set the wind noise
reduction function of the AG-DVC30
(or AG-DVC32) to OFF.
<Note>
On the AG-HMC40P
HMC41E) the "WIND CUT" function
automatically switches to OFF.
MIC:
Set the switch to MIC when a
microphone has been connected to
the XLR connector.
The input level can be switched
using the ATT switch 4.
4ATT switch
Use this to switch the audio input level.
ON: –50 dBu, OFF: –60 dBu
The switch setting takes effect when
the MIC/LINE switch 3 has been set
to the MIC position.
<Note>
When using the AG-MC200G, please
put it in the ON position. If used in the
OFF position,
sensitive and may cause noise to be
recorded.
to the position
(or AG-
it becomes more