SCHUNK PPU- E Series Inbetriebnahmeanleitung Seite 41

1 Wire drive control unit IndraDrive to motor and higher-order
controller in accordance with the connection schematics.
2 Create connection between PC and controller.
ATTENTION
The control unit has the IP address 192.168.0.1
(default setting) a profibus device has the IP address
192.168.0.1.1. The PC interface must have a similar IP address,
e.g. 192.168.0.11 the subnet mask must also be identical:
255.255.255.0.
3 To set the IP address, the Enter key must be pressed. It
appears the menu: There, the IP address can be set.
(Please note that the IP address may not be the same. Ongo-
ing IP distribution is desired.)
Fig. 1
4 Use the arrow keys to navigate to "EtherNet" menu
Fig. 2
5 Then confirm with "Enter"
commissioning
01.00|IndraDrive CS |en
39