Technical Data - JENCONS Powerpette Pro Gebrauchsanweisung

Introduction
The Jencons Powerpette
tured as lightweight, cordless pipetting aids for use with all plastic or glass pipettes from 1–100ml.
These new Powerpettes are constructed in recyclable materials and operate on two rechargeable, long
life, environmentally friendly, 1.2V nickel metal hydride batteries. Powerpettes have uniquely formed fin-
ger triggers to minimize any high pressure points. These triggers also control intake and dispense speeds.
A battery warning light (4) is triggered whenever the charge in the batteries is low and they should then
be recharged. Pipetting with Powerpettes can also take place while the units are connected to their
chargers (5).
Powerpettes have a conveniently located slide switch (3) which allows the user to select between three
modes of operation:
Slide switch position 'High' (top)
Slide switch position 'Low' (middle)
Slide switch position 'G' (bottom)

Technical Data

Batteries
Battery service Life
Charger
Overall weight
Filter (8)
Case material
Nosecone material
Pipette holder
Pipette types
2
Pro and Powerpette
® ®
Suction and dispense at full speed (Blow-out)
Suction and dispense at reduced speed (Blow-out)
Suction at reduced speed, dispense by gravity (To Deliver)
2 x 1.2V nickel metal hydride
500–1000 cycles from empty
75mA/h for 14 hours plug-in; UK, European, USA, Indian,
Japanese or Australian versions
Installation (over voltage) category II
Double insulation indicated on charger by symbol
180g without stand
Hydrophobic 25mm dia 0.45µm (fitted) plus two
additional spare filters
1x 0.45µm
1x 0.20µm
ASA
(10) ASA – Powerpette Pro/ ABS – Powerpette Quicksilver
Silicone (9)
Plastic or glass 1–100ml
Pro & Quicksilver Operator Instructions
Quicksilver have been carefully designed and manufac-