FujiFilm instax SQUARE SQ20 Bedienungsanleitung Seite 20

Printing
⁄
Adjust the image effect as necessary.
(Pages 20 and 21)
@
Press the (Print) button.
The screen below appears.
¤
Press the MENU/OK button.
Printing starts.
• To cancel printing press the
#
(Back) button.
When the film has been
ejected (the camera stops
making a sound), grab the
edges of the film, then take
it out.
■ Film remaining indication
Dots on the right of the monitor indicates the number
of remaining films.
One dot turns gray every time you print an image.
• When there are only two films left, the dots
will turn red.
R For still picture, you can print an image that is zoomed
in or print four or nine images on one film. Use the
command dial to change to the multiple image display
on step 2 when the image to print is displayed. (Page
15)
• For details on taking out the film, refer to the
instructions and warnings on the FUJIFILM Instant
Film "instax SQUARE" pack.
• The development time is approximately 90 seconds.
(The time varies depending on the ambient
temperature.)
EN
19