BRAX MATRIX X2 Bedienungsanleitung Seite 20

4-5 Connectors for a BRAX Power Stabilizer
By connecting a BRAX Power Stabilizer peak loads in the power supply will be eliminated. Thus, the amplifier has always
enough power for a perfect performance.
Equipment and control units
6 Loudspeaker terminals
To connect the speaker cables. Never connect the loudspeaker cables with the car chassis ground. It damages your
amplifier. All speaker systems must be connected in-phase, this means plus to plus and minus to minus. Inverting plus and
minus will result in the loss of bass rendition. The positive terminal is marked on most speakers.
7-8 CPS - Colour Protection System
The LEDs show the operation status of the amplifier. Yellow (11) = malfunction: short-circuit at speaker output;
Red (12) = overheated: If the amp shuts off due to overheating it will take some time (depending on the outside tempera-
ture) until it switches on again.
9 Stereo/Bridged/Mono selector
To select the mode of the amplifier.
Stereo: Select the STEREO MODE for using the channels A and B in the 2-channel mode. The respective LED (STEREO)
lights up blue.
Stereo Bridged: Select the stereo bridged mode for using the channels A and B in the mono mode. In this mode both chan-
nels are bridged to one channel (mono). The respective LED (ST.BRGD) lights up blue. At position STEREO BRIDGED
both inputs A and B have to be used.
Mono Bridged: According to the mode stereo bridged the amplifier is switched to mono and both channels will be bridged
to one channel. If you select MONO BRIDGED only the input A has to be used. This can be necessary if there is only
one mono signal available. The respective LED (MONO BRGD) lights up blue.
20