Telcoma PASSO Installationsanweisungen Seite 52

GB
PROGRAMMING – MODIFICATION OF THE OUTPUT RELAY
The receiver's output relays are pulse-type, meaning that they activate
for a second following each correct code. To modify them, proceed as
follows:
·
press and hold the key for approx. 2 seconds until the keypad be-
eps once.
·
introduce the MASTER code followed by , the LED
·
enter 51# to modify the channel output 1 of the receiver or
dify the channel output 2 (the LED
·
enter:
·
0# for the Step-by-Step mode that is activated with a correct code
and is deactivated after a new correct code
·
1# for the pulse mode, 1 second
·
2# to 255#
seconds the relay remains energized.
The keypad beeps and the LED
Example
I want to program relay 1 with the Step-by-Step output
# 2233#
2 sec. MASTER code command
Example 2
I want to program relay 2 with the timer output at 120 seconds
# 2233#
2 sec. MASTER code command
52
#
for the timer mode where the number corresponds to the
51#
52#
#
☼ starts to flash).
☼ switches off.
0#
step-by-step mode
120#
number of seconds
☼ remains on.
52# to mo-