Plantronics DuoPro Benutzerhinweise Seite 4

UK
DIAGRAM KEY
1 Adjustable Headband
2 Stabiliser Bars
3 Receiver
4 Ear Cushion
5 Headset Cable
6 Noise-Cancelling
Microphone Boom
HEADSET ASSEMBLY: OVER-THE-HEAD
To identify headset components, please refer to the above
diagram key (1-12). For assembly instructions, please refer to
the diagrams A-F on page 3.
Please note that the headset is supplied configured for right ear
use. If this is how you wish to wear the headset refer to Fig A-C.
Fig A. Ensuring that the pivot pin holder on the headband is facing
forwards, push the pivot pin on the receiver into the pivot
pin holder.
Fig B. Press the headset cable into the cable stabiliser channel and
then connect the headset cable to your telephone or amplifier.
Fig C. Adjust the headband length so the stabiliser bars rest gently
above your ears. Then push the receiver close to your ear until
it feels comfortable. Position the noise-cancelling microphone
or voice tube towards your mouth. Adjust the position of the
boom by either raising or lowering the boom or swivelling the
headset forward and backwards from the pivot point. You are
now ready to make and receive calls.
7
7 Voice Tube Boom
8 Pivot Pin
9 Pivot Pin Holder
10 Cable Stabiliser Channel
11 Earloop
12 Earloop Cable Retainer
To convert to left ear use refer to Fig D-E.
Fig D. To convert the headset for left ear use, first pull out the front
part of the boom (on noise-cancelling models) then rotate it
downward so that it faces the opposite direction. Voice tubes
should simply be rotated.
Fig E. Rotate the receiver downward in the opposite direction to the
boom. The headset is now converted for left ear wear.
Fig F. Quick Disconnect™ Connector – This feature allows you to
move away from the telephone wearing your headset without
disconnecting your call. Before using your headset, join the
connectors together. To move away from your desk, pull the
connectors apart. To resume your call, reconnect.
Clothing Clip – The clothing clip helps to keep the headset free
from the weight of the headset cable. Attach the clip to your
clothing at a comfortable level.
HEADSET ASSEMBLY: OVER-THE-EAR
To identify headset components, please refer to the diagram key
(1-12). For assembly instructions, please refer to the diagrams
G-L on page 4.
Please note that the headset is supplied configured for right ear
use. If this is how you wish to wear the headset refer to Fig G-I.
Fig G. Push the pivot pin on the receiver into the pivot pin holder on
the earloop.
Fig H. Press the headset cable into the earloop cable retainer on the
earloop and secure within the notches. Connect the headset
cable to your telephone or amplifer.
Fig I. To position the headset move the earloop away from the receiver
and place the earloop over your ear. Then push the receiver close
to your ear until it feels comfortable. Position the noise-cancelling
microphone or voice tube towards your mouth. Adjust the position
of the boom by either raising or lowering the boom or swivelling
the headset forward and backwards from the pivot point. You are
now ready to make and receive calls.
UK
8