Instructions For Handling Assemblies Susceptible To Electrostatic Shock - Siemens SCD 1815-I Betriebsanleitung

1.2.1. Instructions for Handling Assemblies Susceptible to
Electrostatic Shock
Most of the assemblies within the SCD 1815-I LCD-monitor contain components which can
be destroyed by electrostatic voltages. It is also possible for the assemblies to be damaged in
such a way that total failure does not occur.
If you (as an authorised service technician) are handling such assemblies then the following
precautions should be observed:
•
When such assemblies are being handled, a means of electrostatic discharge must be
available. This can be, for example, an earthed object, which can be touched to discharge
electrostatic voltages.
•
This applies to all tools used (insulated). They must also be discharged at an earthed
object.
•
When assemblies are removed or added to the system, the unit must always be switched
off and the power supply cable disconnected.
•
Vulnerable assemblies should always be held by their edges. Avoid touching tracks and
contact pins.
1815
LCD-Monitor SCD -I
page 33 / 60
Operating Instruction
DOC-No.: B30056DE6.doc