Sabo 92-13H Betriebsanleitung Seite 50

eng 10
Push the pin in using a hammer, ensuring that it comes completely through to the
opposite side.
NOTE
the same size as the pin to push it in the last part.
FITTING THE SEAT
Fit the seat (1) onto the plate (2) using the
screws (3).
ASSEMBLY AND CONNECTING THE BATTERY
Position the battery (1) in its compartment
under the seat.
Connect the two red cables (2) to the positive
terminal (+) and the three black cables (3) to
the negative terminal (–) using the supplied
screws and following the illustrated
sequence.
Fit the spring (4) to hold the battery in place
and make sure all the wires are in front of the
battery so that they don't get caught in the
spring (4).
IMPORTANT
battery according to the instructions in the
battery booklet.
IMPORTANT
ting in, never start the engine until the battery is fully charged!
WARNING!
!
safe handling and disposal.
To avoid damaging the hub, use an awl or a screw-driver of
Always fully charge the
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
UNPACKING AND ASSEMBLY
2
3 3
2
1 4
1
3