Operational Elements And Connections; Remote Control - Magnat MA 600 Wichtige Hinweise Zur Installation

OPeRATIONAl eleMeNTS AND CONNeCTIONS – fRONT PANel
1 ON/STBY
Switches the device on when it is in the standby
mode. If the LED does not illuminate, actuate
the power switch located on the rear of the
device. conversely the device can be switched
from power operation to the standby mode.
2 leD STATUS INDICATION
This illuminated display indicates the MA 600's
2 possible states:
• LED is illuminated green: The MA 600 is
switched on. The device is ready for use.
• LED is illuminated red: The MA 600 is in the
standby mode.
3 SOURCe (INPUT SeleCTOR SWITCH)
Switches between the different audio sources:
• CD: cD player.
• TUNeR: Radio reception device.
• PHONO: Record players with a magnet
system (MM).
• AUx: Other audio device (e.g. MD
player).
• TAPe: Tape or cassette recorder.
• lINe IN: Front input for portable devices
1 2
• USB: connecting to a computer with a
USB port
• BT: connection to a Bluetooth device
• OPTICAl, COAx: connecting to digital
audio sources.
4 DISPlAY
The following information is indicated in the
display:
• Heating phase of the tube: WARM UP 15
This lasts for around 15 seconds after the
device has been switched on.
• Selected audio input:
PHONO, cD, TUNER, AUX, TAPE,
LINE IN, USB, BT, OPTIcAL, cOAX
• Volume muting:
VOL 15
MUTING
• Menu settings
5 lINe-IN
3.5 mm stereo input jack for an auxiliary audio
device (e.g. MP3 player, etc.).
8
3 4 5
6
6 VOlUMe/MeNU
Turn: For adjusting the overall volume of the
music.
Press: Launches the menu for adjusting tone
and for configuring the inputs. Turning the
VOLUME knob navigates through the menu.
7 HeADPHONeS
6.3 mm stereo output jack for headphones.
The speakers are deactivated when this jack
is used. Set the volume to a low level before
connecting headphones.
8 SeNSOR fOR THe ReMOTe CONTROl
Please aim at this sensor when using the
remote control.
10
7