Operational Elements And Connections - Magnat RV 3 Bedienungsanleitung

oPeRAtIoNAl eleMeNtS AND coNNectIoNS – fRoNt PANel
1 2 3
1 Power
Switches the device on. the leD (2)
illuminates green. if the device is switched
off, it is completely disconnected from
the mains supply. this switched off state
means that the rv 3 does not consume
any electricity at all.
3 Balance control
for adjusting the stereo balance between
the speakers to the right or to the left.
4 Volume
for adjusting the overall volume of the
music.
5 Input selector switch SouRce
Switches between different audio sources:
• Phono MC: Record players with Moving
Coil System (MC).
• phono mm: Record players with a magnet
system (MM) or MC system with high
output level (high output MC).
• CD: CD player.
• tuner: Radio reception device.
• Aux: Other audio device (e.g. MP3
player).
• tape: Tape or cassette recorder.
4 5 6 7
6 Display
the following information is indicated in the
display:
• Heating phase of the tubes: WARM uP
• Selected audio input
PHoNo MM - PHoNo Mc - tuNeR -
cD - AuX - tAPe - lINe
• Increasing/decreasing volume
• Volume muting: MutING
• Protect-Mode (in the event
malfunctions):
PRotect
7 Infrared sensor
When using the remote control it must be
aimed at this sensor.
8 Headphones
6.3 mm stereo output jack for headphones.
the speakers are deactivated when this
jack is used. Set the volume to a low level
before connecting headphones.
oPeRAtIoNAl eleMeNtS AND coNNectIoNS – ReAR / coNNectIoNS
R
L
19 18 17 16 15 14
8
9 Mains connection
for connecting the supplied mains cable.
the safety fuse should only be changed by
qualified service personnel.
10 Speaker terminals
for the connection of stereo speakers
with an impedance rating of 4-8 ohms
(the correct polarity must be taken into
account). (See also page 11.)
of
ANAloGue RcA coNNectIoNS
for connecting analogue audio devices.
please observe the coloured marking of
the sockets and connectors. red is always
the right channel.
11 PRe out
preamplifier output for connecting an
external power amplifier or a powered
subwoofer. the output level depends on
the position of the volume knob.
12 Rec out
for connecting devices for analogue
sound recording (e.g. tape recorder). the
signal for the selected audio source with
10
Main
Bi-
Wiring
13 12 11 10
fixed level applies for this output, i.e. it is
independent of the position of the volume
knob.
13 tAPe input
for the connection of a cassette deck or
tape recorder.
14 AuX input
Connection of another audio source (e.g.
mp3 or minidisc player).
15 tuNeR input
Connection of a radio reception device.
16 cD input
Connection of a CD player.
17 PHoNo MM input
Connection of a record player with a
magnet system (MM) or MC system with
high output level (high output MC).
18 PHoNo Mc input
Connection of a record player with Moving
Coil System (MC).
19 PHoNo earth connection
Connection of the phono cable's earth wire
in order to prevent humming.
9