Abus TVVR60011 Bedienungsanleitung Seite 109

Record
Setting up
Open the main menu and click on record:
Schedule
The schedule is used to specify the recording times and
triggers (recording type) for the cameras. Click on the
"Schedule" tab:
Note
Because there is no difference between the set-
tings for the TABs record and instant image, these
are only listed once.
In the OSD, the hours of the respective days are listed
from left to right (the days are listed from top to bottom).
A colour key is shown underneath the days (i.e. the re-
cording periods in the schedule are shown in colour ac-
cording to the trigger (recording types)).
Colour symbol Key
Blue Normal recording: Period in hours
Yellow Motion detection
Light blue Motion detection and alarm
Red Alarm
Grey No selection
Brown Motion or alarm

Select the camera and click on the check box Ena-
ble Schedule.

Click on Edit to specify the type and duration of the
time plan
109
1. Define the day to be set in the pull-down menu at
'Schedule'.
2. Activate/deactivate 'All day'. If the full day is active, no
definite times can be entered as the setting is now val-
id for the whole day.
3. To make specific time settings, deactivate the "All
Day" box.
Application example
Recording should run from 11:00 to 07:00. 2 time
zones must be set up for this:
1. 11:00 AM - 24:00PM
2. 00:00 AM - 7:00 AM
4. Specify the recording type in the drop-down menu:

Time

Motion detection

Alarm

Motion detection or alarm

Motion detection and alarm
Note
To record using motion detection or the alarm, you
must first set this up in the Camera menu (see p.
Fehler! Textmarke nicht definiert. "Setting up of
zones") or Configuration (see p. Fehler!
Textmarke nicht definiert."Alarm").
5. When making a specific time setting, you can define
up to 8 time periods (each from 00:00 to 24:00). The
times in the individual periods must not overlap.
Note
The "Time" recording type defines the time win-
dow where a recording is made.
The other events (e.g. motion detection and/or
alarm) only trigger the recording after the specific
event has occurred.
Settings