Herunterladen Inhalt Inhalt Diese Seite drucken

Preparation; Operation; Maintenance And Storage; Additional Safety Instructions For Devices With Collecting Containers - Mantis LH 3000 A Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Worn out or damaged components must be replaced
immediately for reasons of safety. Only use original
replacement parts. Using non-original parts can lead
to defective functioning and injury.
Only use the shredder in areas in which it is protected
from water. Do not expose the device to rain.
Store the shredder in a dry and secure location and
out of the reach of children.
Younger, disabled or frail individuals may not use this
device without supervision.
Supervise children in the proximity of the device to
ensure that they do not play with the machine.

2.1 Preparation

Do not allow children to work with this device.
Do not use this device in the presence of bystanders.
Always wear ear and eye protection during operation.
Avoid wearing loose-fitting clothing and clothing with
hanging straps and bands.
Only use the machine with plenty of open space (e.g.
not next to a wall or other fixed objects) and on a
solid, even surface.
Do not use the machine on a paved surface or on grav-
el where ejected objects could case injury.
Before using, check all screws, nuts bolts and other
fastening equipment to ensure that they are secure.
Also check the protection and shielding equipment.
Replace damaged and illegible stickers.

2.2 Operation

Before activation, inspect the collection container to
ensure that it is empty.
Do not place your face or body near the feeding fun-
nel.
Do not place hands, other body parts, or clothing into
the feeding funnel or ejection opening.
Always place both feet on the ground securely. Do not
bend over the unit. When feeding the machine never
stand higher than the surface on which the machine
is located.
Always keep clear of the ejection area during opera-
tion.
When adding material thoroughly ensure that there
are no pieces of metal, stones, bottles, cans or other
foreign objects.
If the a foreign object ends up in the cutting mecha-
nism or if the machine starts to produce unusual
noises or vibrations, shut down the device, wait until
the blade stops, unplug the device from the mains,
remove the sparkplug cable and the sparkplug, and
proceed as follows:
1. Check the damages.
2. Check for loose parts and tighten them.
3. Replace any damaged parts or repair with replace-
ment parts (with the same specifications).
Electric Garden Shredder Operating Instructions
Do not let the shredded material pile up in the ejection
area. This could prevent proper ejection or cause this
material to recoil through the filling opening.
If the machine starts to clog, shut it down (unplug the
device from the mains) before fixing the clog. Keep
the power unit free from waste and other build-up to
avoid damage and potential risk of fire. Remember
that the blades continue to operate after the machine
is shut down.
Keep all protection and shielding equipment in good
condition.
Do not tinker with the motor controller settings. The
controller regulates the safe maximum speed and
protects the motor and all moving parts from dam-
ages caused by excessive speeds. In the event of an
issue, seek out specialised help.
Always shut down the shredder (power unit must be
disconnected from the mains) when you leave the
work area.
Do not tilt the machine when the motor is running.

2.3 Maintenance and Storage

If the machine is deactivated for maintenance, in-
spection, storage, or for exchanging a part, (power
unit must be disconnected from the mains), ensure
that all moving parts are still and any tools/spanners
have been removed. Let the machine cool before any
inspection or repair.
When maintaining the blade mechanism, make sure
that the the power source cannot activate due to the
protective locking device; the blades could always be
activated by a hand-start mechanism.
2.4 Additional Safety Instructions for De-
vices with Collecting Containers
Shut down the shredder before attaching or removing
the collecting container.

3. Intended Use

This machine is only intended for private use, not to be
used professionally. The compost grinder is designed to
grind organic material such as dry plant residue, twigs,
sticks and branches.
The machine is not allowed to be used in commercial ap-
plications. Any use not in accordance with this designated
use shall be regarded as misuse.
This can result in injuries!
WARNING! For your own safety, please
read this handbook and the general safe-
ty instructions thoroughly before operat-
ing the unit. If you give the unit to some-
one else, always include this instruction
manual.
GB-4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis