Storage; Repair Service; Waste Disposal And Environmental Protection; Technical Data - Mantis LH 3000 A Gebrauchsanweisung

6. Always have any damaged, or worn parts repaired, or
replaced by qualified personnel.
7. Do not use any cleaning or solvent materials as these
could cause irreparable damage to your machine.
Chemicals could destroy the artificial materials.
8. The strength of the fastening screws of the frame
should be checked from time to time.
9. Oil the blade after every fourth or fifth use.
CAUTION
1. Do not over tighten the plate adjustment screw and
cut excessive aluminium off of the plate, as this will
reduce the life of your shredder.
2. Have your garden shredder inspected and maintained
by qualified service personnel. Do not attempt to re-
pair the machine unless you are qualified to do so.

9. Storage

In order to protect the shredder from corrosion during ex-
tended storage, apply some environmentally friendly oil
to the blade.
Make sure that the garden shredder has been thoroughly
cleaned before storing it in a clean, dry place out of the
reach of children.

10. Repair Service

Attention! Electrical repairs may only be
carried out by a skilled electrician or a
customer service workshop!
If you send the machine to us for repair, please describe
the fault.
Europe Mantis France SARL
20, rue des Garennes
57155 Marly
France
Phone: 0800 988 4828 (UK Freephone)
11. Waste disposal and environ-
mental protection
Dispose of the machine properly after it is worn out. Dis-
connect the mains cable in order to prevent misuse. Do
not dispose of the machine with the household waste. In
the interest of environmental protection, take it to a col-
lection point for electric machines. Your responsible local
authority can provide you with addresses and operating
times. Also take the packaging materials and worn out
accessories to the appropriate collection points.
Only for EU countries
Do not discard electric tools in the household
waste!
In accordance with European Directive 2012/19/EC on
waste electrical and electronic equipment and its imple-
GB-7
Contact us at www.mantis.uk.com
mentation in national law, waste electric tools must be col-
lected separately for environmentally-compatible re-use.
Recycling alternative to the return invitation:
Instead of returning the electric equipment, the owner is
alternatively obligated to take part in the proper recycling
in the case of relinquishment of ownership. The waste
equipment can also be taken to a collection facility which
disposes of it in the sense of the national recycling man-
agement and waste acts. This does not pertain to the ac-
cessory parts and auxiliary equipment without electrical
components accompanying the waste equipment.

12. Technical Data

Electric Silent Shredder
Nominal voltage
Nominal frequency
Nominal power
No-load speed
Max.branch diameter
Collecting container
Weight
Sound pressure level dB(A)
(EN 50434A:2014)
Sound power level L
WA
(2000/14/EG)
Service life S6 40%(full load: 40 sec., no-load: 60 sec.)
Class of protection II; Schutzart IP24
Technical and visual changes can be made during the
course of the further development and without prior no-
tice. All information given in these instructions for use are
therefore given without guarantee. Legal claims, which
are based on the instructions for use can therefore not
be made.

13. Spare parts

Please contact our service department if you need acces-
sories or spare parts.
MANTIS UK Customer Service:
0800 988 4828 (UK Freephone)
Or visit our website:
www.mantis.uk.com/mantis-parts-and-services/
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to per-
sons or damage to the machine.
The following information should be provided when order-
ing spare parts:
• Type of machine
• Item number of the machine
LH 3000 A
V~ 230-240
Hz 50
W 3000 (S6,40%)
rpm 60
mm 44
liter 60
kg 23,5
70,3 (K=3 dB(A))
dB(A) 92