Safety recommendations
•
Please ensure to only use the mains supply and the rechargeable battery delivered to you with the RTP 700.
•
If the printer is not being used for a longer period of time, ensure to remove the battery. Otherwise, the
rechargeable battery or the printer can be damaged (corrosive fluid could leak from the battery).
•
Do not open the cover of the paper roll during printing, as this may cause the printer to malfunction.
•
The thermal printhead is a component that can heat up. Do not touch the printhead or the surrounding parts
during or after printing.
•
If the ERROR light blinks twice and then continuously glows for 5 seconds, this indicates overvoltage of the
device. In this case, please verify whether the appropriate power supply is used.
•
Do not exceed the length of the printed receipts by more than 1 meter. Otherwise, the printer could be da-
maged.
•
If the ambient temperature is too high (above 45 °C) or too low (below 5 °C) and/or if the ambient relative
humidity is too high (above 85%) or too low (below 20%), this will result in poor print quality.
•
Please make sure to use up the power of the battery completely before recharging the battery. This ensures
the service life of the rechargeable battery.
•
The thermal paper should not be exposed to high ambient temperatures or direct sunlight. In order to keep
the receipts for a longer period of time, ensure to select thermal paper, which is effective for a longer dura-
tion.
•
To avoid overheating, do not expose the printer to direct sunlight.
[ EN]
7