Insert The Battery; Charging The Battery - ratiotec RTP 700 Bedienungsanleitung

[EN]

Insert the battery

Insert the rechargeable battery (supplied) into the battery compartment on the back of the thermal receipt printer.
Insert a thermal roll
1. If the paper roll is empty, the red ERROR light will light up.
2. Open the top cover of the device.
3. Insert the paper roll. Pull out a small amount of paper and close the top cover again.
4. Switch on the thermal receipt printer.
5.
Press the FEED key in order to advance the paper. Advancement of the paper stops as soon as the FEED key
is released.
Note: Please make sure that the thermally printable side of the paper faces up. Otherwise, the printed informa-
tion will not be visible.
Only use paper rolls with the following features:
Paper: Thermal paper
Width of the roll: 58 mm
Max. Diameter of roll: 40 mm
Operation
Switch on/off: Press the POWER button for 2 seconds to turn the device on or off. When turning on the printer, the
green POWER light appears. When turning the printer off, all the lights extinguish.
Note: When the battery power is low, the red POWER light appears. Recharge or change the battery before pro-
ceeding with printing.

Charging the battery

Plug the power adapter into the wall outlet, then connect the AC power cord to the printer. While the battery is
charging, the red battery status light appears The indicator turns green when the battery is fully charged (after
about 2 hours).
4