ratiotec RTP 700 Bedienungsanleitung Seite 5

Use via Bluetooth (ratiotec Connect products)
Initial usage:
Before using the RTP 700 thermal receipt printer for the first time with the Connect billing devices, it must be
added to the Connect Box's administration website. Please ensure the printer is switched on.
The exact procedure can be found in the user manual of the Connect Box (section "Set up Bluetooth billing
devices and thermal receipt printers").
The name of the printer is displayed as RTP 700; the password is 1234.
Once the RTP 700 has been added, it can be used with coupled Connect billing devices.
Print-out of counting results:
Please ensure that the RTP 700 is switched on. Use the Connect billing device to proceed with the counting pro-
cedure, and then press the "Print" button (on the rapidcount T series press the "Report" button, on the RS 2000
money scale press the "OK" button for 2 seconds).
At first the data are transmitted to the Connect Box and then forwarded to the thermal receipt printer. This may
take several seconds. While the receipt printer receives the data, the blue Bluetooth light appears. Subsequent-
ly, the information is printed.
Using the cable
The printer may also be used with some ratiotec billing devices through the enclosed standard cable (RS-232 to
serial port); for example with rapidcount S 225, S 275, X 400 or X 500.
[ EN]
5