DJI Ronin 2 Kurzanleitung Seite 6

D. Slide the camera into the mounting plate until the safety lock engages, then lock the lever
1
E. Attach the upper crossbar and tighten the securing knob
2
The roll axis arm can be extended if there isn't sufficient mounting space for a large camera. Loosen the screws
on both sides of the roll axis to pull out the arm.
Before balancing the camera, connect the SDI cable and the camera's power cable, and install a Focus system.
Balancing
A. Balancing the Vertical Tilt
a. Unlock the tilt axis. Rotate the tilt axis so that the camera lens is pointing up.
b. Push up on the side levers
turning the adjustment knob
tilting up or down.
c. Tighten the levers
B. Balancing Depth for the Tilt Axis
a. Rotate the tilt axis so that the camera lens is pointing forward.
b. Toggle the lever
1
camera's balance by turning the adjusting knob
45 degrees upwards or downwards.
c. Tighten the securing knob
d. Lock the tilt axis.
2
1
1
to their unlocked position. Then adjust the camera's balance by
1
. Make adjustments until the camera appears balanced without
2
.
3
1
to the unlocked position and then loosen the top securing knob
and toggle the lever
4
RONIN 2 Quick Start Guide
to the camera, then lock the levers
3
2
until the camera remains still when rotating the tilt axis
3
to the lock position.
5
3
©
2017 DJI OSMO All Rights Reserved.
.
2
.
4
3
4
3
. Adjust the
2
4
5
5