Clock And Calendar; Clock Reception - Oregon Scientific RMR500A Bedienungsanleitung

To search for a sensor:
Press and hold + at the same time.
The remote sensor reception icon will show the following
status:
ICON
TIP
The transmission range may vary depending on many
factors. You may need to experiment with various locations
to get the best results.

CLOCK AND CALENDAR

NOTE
If optional sensors are installed:
• clock and calendar display will be replaced by
temperature/humidity readings.
• press to toggle between clock and temperature/
humidity display, or calendar and temperature/humidity
display; the display will return to temperature/humidity
display after 1 minute.
DESCRIPTION
Main unit is searching for
sensor(s).
A channel has been found.
The sensor cannot be
found.

CLOCK RECEPTION

This product is designed to synchronize its clock
automatically with a clock signal.
RMR500:
Slide EU / UK to select the signal received.
• EU: DCF-77 signal: within 1500 km (932 miles) of
Frankfurt, Germany.
• UK: MSF-60 signal: within 1500 km (932 miles) of
Anthorn, England.
RMR500A:
WWVB-60 signal: within 3200 km (2000 miles) of Fort
Collins, Colorado.
To enable / disable clock signal reception:
Press and hold
to enable or
reception.
NOTE
Reception takes 2-10 minutes. If the signal is weak,
it can take up to 24 hours to get a valid signal. If signal
reception is unsuccessful, place your unit next to a window,
press and hold to force another signal search.
5
to disable clock signal