Stand-Alone Mode; Master/Slave Mode; Master Unit - HQ Power HQLE10036 Bedienungsanleitung

6.2 Menu
mode
auto
sound
speed
sensitivity
silent scene
InFr
addr
slave
display
6.3

Stand-Alone Mode

The device starts running in stand-alone mode after connection to the mains. This mode
allows you to use the device without controller.
Connect the device to the mains to switch it on. Press MENU to enter the menu. Select
the auto mode and confirm.
6.4

Master/Slave Mode

The master/slave mode allows for connecting several devices to a single master device
in a daisy chain. All slave devices will then work synchronously with the master device.
Configure all slave units before connecting the master unit to the daisy chain. The
maximum number of slave units you can connect to a master unit is 18.
Slave Units
Connect the DMX input from your slave device to the DMX output of the previous device
in the chain. Connect the slave device to the mains to switch it on. Repeat these steps
for all slave units.

Master Unit

Connect the master device to the mains to switch it on. Press MENU to enter the menu.
Set the master unit to work in one of the running modes. Connect the master unit as
the first unit in the chain by connecting the DMX output of the master device to the
DMX input of the first slave unit.
V. 03 – 18/07/2018
HQLE10036
programme
Au1-Au7 auto programme
So1-So7 sound programme
SP1-SP9 adjustable speed value
Se1-Se9 adjustable microphone value
OFF open on music by sound programme
ON closed on music by sound programme
ON enable IR remote reception
OFF disable IR remote reception
4CH 4-channel DMX mode
13CH 13-channel DMX mode
slav slave mode
dISP normal display
dSiP inversed display
10
description
d001-d512
d001-d512
©Velleman nv