Connecting The Power Supply Unit - Dometic SMP301-07 Montage- Und Bedienungsanleitung

SMP301-07
6.2

Connecting the power supply unit

Please note that flat plugs P1 – P6 are individually fused via plug-in fuses F1 – F6 in the
following manner:
Flat plug Fuse
P1
P2
P3
P4
P5
P6
➤ Press the two tabs (fig. 3 1, page 4) in the direction indicated by the arrows and
lift the cover off (fig. 3 2, page 4).
➤ Connect the positive terminal of the consumer units to the flat plugs P1 – P5
(fig. 1 11 – 15, page 2).
➤ Connect the negative terminal of the consumer units to one of the flat plugs P7
(any pin) (fig. 1 17, page 2).
➤ Connect the positive terminal of the battery to one of the flat plugs P6 (fig. 1 4,
page 2).
➤ Connect the negative terminal of the battery to one of the flat plugs P7 (any pin)
(fig. 1 17, page 2).
➤ Connect the AC connection cable to the AC plug (fig. 1 1, page 2).
➤ Ensure that the cable length between the battery and the power supply unit is not
more than 2 m.
➤ Secure all cables with strain relief clamps.
EN
Fuse assignment
F1
F2
F3
F4
F5
F6
Installing the power supply unit
Maximum permissible
10 A
10 A
5 A
5 A
10 A
20 A
current
15 A
15 A
15 A
15 A
15 A
20 A
13