Installation; Positioning The Unit; Installation Modes; Minimum Installation Distances - Vasco NIVA FC series Installationsanweisung

POSITIONING THE UNIT

INSTALLATION MODES

MINIMUM

INSTALLATION

DISTANCES
06 INSTALLATION
2 INSTALLATION
Avoid installing the unit in proximity to:
- positions subject to exposure to direct sunlight;
- in proximity to sources of heat;
- in damp areas or places with probable contact with water;
- in places with oil fumes
- places subject to high frequencies.
Make sure that:
- the wall on which the unit is to be installed is strong enough to support the
weight;
- the part of the wall interested does not have pipes or electric wires passing
through;
- the interested wall is perfectly flat;
- there is an area free of obstacles which could interfere with the inlet and
outlet air flow;
- the installation wall is preferably an outside perimeter wall to allow the
discharge of the condensation outside;
The following descriptions of the various mounting phase and the relative
designs refer to a version of the machine with fixtures on the left.
To ensure that the installation is performed correctly and that the appliance will
perform perfectly carefully follow the instructions indicated in this manual. Failure
to respect the rules indicated not only can cause malfunctions of the appliance
but will also invalidate the warranty and hence VASCO shall not respond for any
damage to persons, animals or property.
Figure indicates the minimum mounting distances between the wall-mounted
cooler-convector and furniture present in the room.