Maintenance - auna Nostalgy Anschluss- Und Anwendungshinweise

Notes
• To interrupt the music temporarily, press the "PLAY/PAUSE" button. Press the button again to resume
playback.
• If both a USB stick and an SD card are connected, press and hold "PLAY/PAUSE" to select between
USB or SD card.
• It is not guaranteed that all USB memory devices (or SD cards) will work on this audio system.
• The USB port does not support connection with a USB extension cable and it is not designed for
direct communication with a computer.
Record player
• Power on and set the function switch to "PH".
• Set the correct spinning speed and put the tone arm right before the desired track.
Replacing the stylus
Under normal use, the stylus (needle) will last. However, it is recommended that the stylus be replaced
as soon as you notice a change in sound quality. Prolonged use of a worn-out stylus may damage the
record. The higher speed of 78RPM records can wear the stylus at a faster rate.
Notes
• Do not remove or bend the stylus.
• To avoid injury, do not touch the needle.
• Turn off the unit's power before you replace the stylus
• Keep out of the reach of children.
Removing the old stylus
1. Set a screwdriver at the tip of the stylus and push down
to the direction "A".
2. Pull the stylus out toward direction "B".
Installing a new stylus
1. Hold the tip of the stylus and insert the other edge by
pressing toward direction"C".
2. Push the stylus up toward direction "D" until it locks at
the tip.
16

Maintenance

www.auna.de