System-Setup Menus - PSSO DXO-48 Bedienungsanleitung

System-Setup Menus

The System Menus allow the user to control and change parameters that are related to the system
behaviour and general operation. It can be accessed by pressing the SYS key in the main menu, but not if in
Input- or Output-Menu. In this case press the EXIT button first. There are 6 system:
1. Recall - Program Recall Menu
The DXO-48 can store up to 30 program setups. With this menu a program can be recalled.
PROG – program number
NAME – program name
Use the jog-dial to select the desired program. Then press ENTER to recall this program.
The names are read only, the user has no access to them here.
2. Store – Program Store
The DXO-48 can store up to 30 program setups.
PROG – program number
NAME – program name
Use the jog-dial to select the desired memory number. Please note that if on this memory position already is
another program stored this program will be deleted and the new one will be saved. So please make shure
before saving that the memory position is empty or that the program there it not needed anymore.
The program name has a maximum length of 12 characters.
Then press ENTER to save this program.
3. Config – Configuration Menu
Wiht the configuration menu you can very fast and convenient connect the inputs and outputs according to
some basy system hook-ups. These connections can be edited later.
All other parameters like filter type, cut-off frequency and slope still have to be configured manually.
25/32 10356360_V_1_1.DOC