Installation - Miele XKM 3100 WCDS Gebrauchsanweisung

Installation

 Before fitting the communication module compare the connec-
tion data (voltage and frequency) on the data plate with that on the
data plate of your washer-disinfector. If the data does not match,
the module could sustain damage. If in any doubt, consult an elec-
trician.
Take a note of the module serial number. This is required as the

password for establishing the WiFi connection. The serial number
can be found on the data plate located on the side of the module.
XKM 3100 WCDS
M.-Nr.: xx xxx xxx
AC 100-240V 0,02A 50/60Hz
Typ: XKM 3100 W
12/0001234567890
The serial number of the module, without the initial zeroes, acts as
the password. Example:
12/0001234567890
Disconnect the washer-disinfector from the mains electricity supply.

Remove any stickers or protective caps as necessary from the slot

aperture.
Push the module into the module slot. Gently push the module until

it clicks into place.
Connect the washer-disinfector to the electrical supply.

The module is supplied with mains power by the washer-disinfector.
An additional power connection is not required.
en - Fitting and installation
Password: 1234567890
25