Ayce HT31S-5015D Originalbetriebsanleitung Seite 65

CHARGE THE BATTERY (FIG.5)
Attention! Only use charger in dry places, away from moisture and heat
sources.
Before first use, the battery needs to be charged for about 1-2 hours.
Use only the original charger (10).
1. Remove the battery from the device.
2. Align the sliding slots with the battery (4) and slide the charger connector
(11) onto it until it locks in place. (Fig.5-a, Fig.5-b)
11
3. Connect the charger to the power supply. (LED on charger lights up red,
and meanwhile the LED on battery lights up green and blink)
4. After a sufficient charging time (about 2.5 hours, LED on charger lights up
green), disconnect the charger from the power supply.
5. Press the release button and remove the charger connector from the
battery.
NOTE: It is normal for the battery and charger to become warm (but not hot)
during charging process. If the battery does not charge properly, check to
make sure the electrical outlet is "live".
Notes on charger (Fig.6):
• LED on charger lights up red: Battery is charging
• LED on charger lights up green: Charging completed
LED on charger
Fig. 6
10
4
Fig.5
64 65
Fig. 5-a
Fig. 5-b