Eufab 17467 Bedienungsanleitung Seite 8

5. Operating instructions
Attaching the adhesive magnetic metal plate:
If you use a protective case for your mobile telephone, remove this first.
Clean the rear of your mobile telephone to remove dirt, dust and grease. To do this, read the care
instructions in the manual for your mobile telephone. Remove the protective film from the adhesive coating of the
magnetic metal plate. Firmly press the metal plate, as centrally as possible, onto the rear of your mobile
phone.The magnetic metal plate is so thin in its dimensions that the majority of protective cases can be fitted
over the top of it.
Mounting the mobile phone holder:
Fit the hard rubber clamp to one fin of the ventilation grate in your vehicle.
Mounting the mobile telephone to the holder:
Simply place the telephone, with the fitted metal plate, onto the handy holder.
Do not expose your mobile telephone to the direct air flow. Close the relevant ventilation
flap. Otherwise the phone may become overheated when the vehicle heating is running, or
condensation may form when the air conditioning is operating.
Depending on the protective cover used, it is possible that optimum adhesion will not be achieved.
The magnetic plate can be removed from your mobile device by carefully lifting the plate from the rear of the
mobile device using the blade of a knife.
Do not use aggressive cleaners or solvents to remove adhesive residue. For more information, read
the care notes for your mobile device.
The adhesive may cause permanent discolouration of the device surface at the point at which the
adhesive was applied.
To remove the mobile phone holder, pull it carefully off the fins of the ventilation grate. It may be necessary
to hold the fin to prevent the grate and its mechanisms from being damaged.
6. Maintenance and care
When used as directed, the phone holder is maintenance-free.
7. Notes regarding environmental protection
Dispose of the phone holder at the end of its lifetime via the recycling container or the public/municipal
collection points.
The materials are recyclable. You make an important contribution to protecting our environment by recycling,
material utilisation or other forms of reusing waste equipment!
8. Contact information
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
8
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com