Discharging Of The Pb Battery; Nicd/Nimh Battery Program; Charging Of Nicd/Nimh Battery - DF-models I-Peak 6 Bedienungsanleitung

current. Press "Start/Enter" key again to store the parameter value you set. Press "Batt type/
Stop" key to end the program.

Discharging of the Pb battery

Set up the charge current on the left and nominal voltage on the right. Range of discharge current
is 0.1-5.0A, the voltage should match the battery being charged. Press "Start/Enter" key for more
than 3 seconds to start charging.
The screen displays the real-time discharging status. Press "Start/Enter" key to alter discharge
current. Press "Start/Enter" key again to store the parameter value you set. Press "Batt type/
Stop" key to end the program.

NICD/NIMH BATTERY PROGRAM

Charging of NiCd/NiMH battery

• This program is for charging and discharging of NiCd/NiMH batteries associated with R/C
models applications.
You can press "Start/Enter" key to make it blink and then "INC" or "DEC" to change the param-
eter value. Press "Start/Enter" key to store the value.
This program charges the battery using the current you set up. In the "auto" state, you should
set up the upper limit of the charge current to avoid damage by excessive feeding current. Some
batteries of low resistance and capacity can lead to higher current in the "auto" charging mode.
14
Charge current
Battery type
Pb-6 4.0A
CHG 022:43
Elapsed time
Pb
1.0A
Discharge current
Battery type
Pb-6 0.4A
DSC 022:43
Elapsed time
NIMH
CUR
www.df-models.com
Battery voltage
12.59V
00682
Charged capacity
DISCHARGE
12.0V(6P)
Battery voltage
12.59V
00682
Discharged capacity
CHARGE Aut
LIMIT 5.0A