ASROCK 4Core1333-GLAN Bedienungsanleitung Seite 17

Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA
HDD power connector
USB 2.0 Header
(9-pin USB6_7)
(see p.2 No. 18)
DeskExpress Hot Plug Detection
Header
(5-pin IR1)
(see p.2 No. 21)
Internal Audio Connectors
(4-pin CD1)
(CD1: see p.2 No. 25)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 24)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
ASRock 4Core1333-GLAN Motherboard
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
power cable to the power
connect to the
power supply
connector of the power supply.
Besides six default USB 2.0
ports on the I/O panel, there is
one USB 2.0 header on this
motherboard. This USB 2.0
header can support two USB
2.0 ports.
This header supports the Hot
Plug detection function for
ASRock DeskExpress.
This connector allows you
to receive stereo audio input
CD1
from sound sources such as
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.
This is an interface for front
panel audio cable that allows
convenient connection and
control of audio devices.
1 7 1 7 1 7
1 7 1 7