Operation - Husqvarna LB 553S e Bedienungsanweisung

WARNING: Do not operate the product
when the handle is in storage position.
To assemble the handle (LB 553S)
1. Push the engine brake handle in the direction of the
handlebar.(Fig. 18 )
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Examine the cutting equipment to make sure that it
is correctly attached and adjusted. See
the cutting equipment on page 13 .
3. Fill the fuel tank. See
4. Fill the oil tank and do a check of the oil level. See
To do a check of the oil level on page 13 .
To fill fuel
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
To set the cutting height
The cutting height can be adjusted in 5 levels.
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height.(Fig. 21 )
895 - 003 - 16.10.2018
To examine
To fill fuel on page 11 .
2. Fold the upper handle up until it aligns with the lower
handle.(Fig. 19 )
3. Tighten the knobs fully.(Fig. 20 )

Operation

To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2. Open the fuel valve.(Fig. 22 )
3. Stay behind the product.
4. Hold the engine brake handle against the handlebar.
(Fig. 23 )
5. Hold the starter rope handle with your right hand.
6. Slowly pull out the starter rope until you feel some
resistance.
7. Pull with force to start the engine.
To use the drive on the wheels
• For LB 553S e: Push the drive lever down.(Fig. 24 )
• For LB 553S: Pull the drive lever up.(Fig. 25 )
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
• Release the engine brake handle slightly to
disengage the drive, for example when you go near
an obstacle.
To stop the product
• To stop the drive only, release the engine brake
handle a small distance.
• To stop the engine, release the engine brake handle
fully.
• Close the fuel valve.(Fig. 26 )
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
WARNING: Do not twist the starter rope
around your hand.
CAUTION: Do not extend the starter rope
fully. Do not release the starter rope handle
when the starter rope is extended.
11