Replacing The Lamp - AEG SCB51811LS Benutzerinformation

28 www.aeg.com
Problem
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

The appliance is equipped
with a longlife LED interior
light.
It is strongly recommended
to use original spare parts
only.
Possible cause
During the automatic de-
frosting process, frost
melts on the rear plate.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
1. Pull the left side of the lamp cover
with your fingers to unlock it. Remove
the cover by pulling it towards
yourself.
Solution
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from
the mains socket.