Calling Up And Saving Light Scenes; Switching Off The Consumers - Busch-Jaeger 6136/100CB-102 Bedienungsanleitung

7.2.2

Calling up and saving light scenes

Press "Light" button on remote control unit.
– The word "LIGHT" appears in the remote control unit display. This mode is active for 25
seconds. After this, the display goes back to audio/video. Press the LIGHT key one more
time if required.
Switch the light scenes according to the table below.
„LIGHT+A" in the table means that these two keys must be pressed one after the other (not
simultaneously).
Function
Call up light scene 1
Call up light scene 2
Call up light scene 3
Call up light scene 4
Save light scene 1
Save light scene 2
Save light scene 3
Save light scene 4
7.2.3

Switching off the consumers

When pressing the "STOP" button, all consumers can be switched off with one single button.
Keys to be pressed
LIGHT+A
LIGHT+C
LIGHT+D
LIGHT+F
LIGHT+ LIST*+GO+A
LIGHT+ LIST*+GO +C
LIGHT+ LIST*+GO +D
LIGHT+ LIST*+GO +F
* The key LIST must be
pressed until STORE
appears in the display.
ENG
39