Mitsubishi Electric PLA-RP35AA Bedienungshandbuch Seite 17

10. Care and cleaning
I PKA-RP·GAL
1 Pull both the bottom corners of the intake grille to open the grille,
then lift the filter.
I PKA-RP·FAL (2)
1 Hold the filter lug (located at the bottom of the intake grille) and pull it
out downward.
AFilter
BLug
• To reinstall the filters, push the filter lug upward.
I PCA-RP·GA (2)
C
1 Open the intake grille.
2 Hold the knob on the filter then pull the filter up in the direction of an
arrow. To replace the filter after cleaning, be sure to insert the filter far
enough until it fits into the stopper.
AFilter BIntake Grille
I PMH-P·BA
1 Pressing the PUSH button on the outer side of the intake grille causes
the intake grille to open.
2 A filter with an intake grille on it can be removed by pulling the filter
forward.
B
A
A
B
D
CKnob DStopper
I PSA-RP·GA
c
b
• Remove the screw from the suction grille handle.
• The suction grille is open if you pull the handle in arrow direction 1.
• The filter is set inside the suction grille and is open if you pull it in arrow
direction 2.
aSuction grille
bHandle
cScrew
I PCA-RP·HA
A
B
RP71 → → → → → 3 pieces
RP125 → → → → → 4 pieces
s s s s s Cleaning the oil filter (PCA-P·HA Series)
1) Removing the oil filter
1Remove the filter by sliding it in the direction of an arrow.
2) Replacing the filter element
1Remove the oil filter by sliding it in the direction of an arrow.
2Remove the two metal fittings for filter element according to the follow-
ing procedure. Bend the metal fittings towards 1 side (inside) and then
slide them in the direction of 2 to remove.
3Replace the filter element (disposable).
Optional parts: PAC-SG38KF (12 pieces)
Note:
Install the filter element within the frame securely.
4Install the metal fittings for filter element in their original positions.
5Turn the side of oil filter that the metal fittings are installed downward
and install the filter in the unit.
AHandle
BOil filter
3) Cleaning the frame of the oil filter
Tools to be prepared
• Protective goods such as a rubber glove
• Scrubbing brush or brush
Note:
Avoid using a metal scrubbing brush or brush since the aluminum materials
could be damaged.
• Household neutral detergent or alkalescent detergent (for washing dishes
or clothes)
Note:
If alkaline detergent is used for cleaning, the part made of aluminum could discolor.
Note:
Make sure the filter element is removed when cleaning the oil filter.
1If the filter is not so dirty. (If the filter is cleaned once a week (once per
100 operating hours).)
Wash the filter with water and above-mentioned detergent using a scrub-
bing brush or brush, etc. (It is more effective to wash the filter with luke-
warm water.)
2If the filter is extremely dirty.
Put the previously-mentioned detergent (its strength should be about 1/10
of undiluted solution) into hot water whose temperature is 50 °C or less,
and soak the filter for 1 hour or more before washing.
Warning:
To prevent your hand from burning, start washing the filter after the
hot water gets cold.
2
1
a
1
2
C
C Filter element
D Metal fitting for filter element
D
17