Preparing For Session - TensCare perfect mamaTENS Bedienungsanleitung

11.3. PREPARING FOR
SESSION
1) After the lead wires are securely
connected you will need to ask your
birthing partner
electrode pads into the correct
position on your back. To ensure
good adhesion of pads, the area of
skin they are going to be applied to
needs to be clean, dry, and free from
grease or powder.
2) Place the top
(connected to CH1) either side of the
spinal column 2 inches (50 mm)
apart from each other and about 3
inches (75 mm) below the bottom of
the shoulder blades
vertebrae T10, T11, T12 and L1).
This is just below the bra line.
3) Place the lower pair of
(connected to CH2) either side of the
spine about 4 inches (100 mm) apart
and about 1 inch (25 mm) above the
dimples at the base of the spine, just
above the buttocks
vertebrae S2, S3 and S4).
Warning: Ensure the perfect
mamaTENS is switched OFF
before applying the electrode
pads on the skin.
to place the
pair of pads
(close to
pads
(close to
18
4) You can safely lean on the electrode
pads. The sensation might change.
5) With the electrodes pads in place
you can choose to use the belt clip or
the neck cord, whichever you are
most comfortable with, so you are
able to remain as mobile as possible.
A belt clip is provided to allow you to
attach the unit to your clothing. It can
be inserted either way up. Slide the
clip along the base of the unit until it
locks in position.
You can also hang the unit from your
neck with the neck cord using the
holes on each shoulder of the unit.
The neck cord is designed to open
for safety if pulled.
Feed a loop of the neck cord through
the hole in the shoulder of the unit
and pull through. Feed cord through
the loop and pull tight towards the
unit.
Warning: Do not use other
cords than the one provided.