Programme B; Programme C - TensCare perfect mamaTENS Bedienungsanleitung

intensity, so you have fine control of the
strength of stimulation.
There are two modes, A1 and A2.
Mode A1 is for
contractions and mode A2 is for use
during contractions.
between the two modes at any time by
pressing the BOOST button.
The perfect mamaTENS will start at
zero intensity. Increase the intensity
until you feel a pulsing on-off-on-off
sensation. When the next contraction
starts press the BOOST button once
and the mode will change to mode A2,
at the same intensity level as it was
when in mode A1. Mode A2 feels like a
constant strong tingling. At the end of
the contraction, press the BOOST
button to return to mode A1. Repeat
this each time a contraction starts. As
the contractions become
simply increase the intensity.

7.2. PROGRAMME B

You should stay in programme A as
long as possible, but when your
contractions intensify and become
more frequent you can progress to
programme B.
Do this by pressing the programme
button P. The LCD screen will display
B1. To avoid discomfort with the
change in programme, the set intensity
will drop by half. This programme has
50 small steps of intensity, so you have
fine control of the
stimulation. Press and release the ▲
button until you reach a comfortable
intensity setting.
use between
You can switch
stronger
strength of
11
Programme B provides you with a
stimulation pattern which is set to block
the heightened pain which you may
suffer.
You will feel that the stimulation in the
higher set of pads CH1 (left channel)
which have been placed just below your
bra line is stronger than the lower set of
pads CH2 (right channel) at the bottom
of your back - this is intentional and part
of the therapy. As the contractions
become more intense and closer
together, increase the intensity.
Note: If the lower electrode
pads feel stronger then the
upper ones then the leads have
probably been incorrectly inserted into
the perfect mamaTENS. To correct
this, change over the leads as per
section 6, and reset the intensity.
Again, there are two modes, B1 and
B2.
The second mode B2 is triggered by
pressing the BOOST button when you
experience a strong contraction. This
mode provides a constant tingling
sensation. When
passes, press the BOOST button once
more and your perfect mamaTENS
unit will change back to mode B1.

7.3. PROGRAMME C

If you find programs A and B do not
meet your needs for pain relief there is
a third program C, which provides a
higher level of pain relief.
Press the programme button P again
and this will take you to programme C
the contraction