Operation Of Hp01 Overlap Welding; Preparation; Insert Profile Within The Mould - BEHAbelt HP01 Bedienungsanleitung

6.0 Operation of HP01 overlap welding

60mm/2inch
6.1

Preparation

Determine the belt length and add one time the overlap length. Cut belt ends for overlap
welding above the reinforcement. Here some residual material on the reinforcement may
be present. Don't cut into the reinforcement! We recommend our specially developed
60mm/2inch
cutting device (see page 31
60mm/2inch
6.2 Insert profi le within the mould
The profi le and mould must be the same type.
Remove the shell and insert the profi le in the lower part.
38
60mm/2inch
= 2mm / 0,08 inch remaining material
)
7
60mm/2inch
60mm/2inch
= 2mm / 0,08 inch
60mm/2inch
60mm/2inch
Fill the water tank to the upper edge of the second ring with water
60mm/2inch
when using water cooling.
Attention: Do not position the connected cooling unit above
the press
-> water can heating up!
After every second consecutive welding replace water with
60mm/2inch
cold water!
60mm/2inch
remaining material
Cut the ends of the belt as shown in fi gure with a
45° phase.
Select mould and ready place.
before your
Insert the two ends of the middle and fi x it with
the clamping screws on the sides. The cutted belt
ends lie fl ush with overlapping.
The milled notch of the mould show the middle of
the upper and lower parts.
60mm/2inch
= 2mm / 0,08 inch
60mm/2inch
60mm/2inch
60mm/2inch
start the cooling
remaining material
process