Polar CK640 Bedienungsanleitung Seite 9

If the temperature •
measured by •
the pin probe •
reaches the •
chilling endpoint
temperature prior
to expiry of the
maximum chilling
time duration:
If the temperature •
measured by the
•
pin probe does
•
not reach the
•
chilling endpoint
temperature prior
to expiry of the
maximum chilling
time duration:
When the
•
temperature
•
measured by
•
the pin probe
•
reaches the
•
chilling endpoint
temperature:
During storage:
•
•
•
•
To interrupt the
•
cycle:
Set-Temperature Negative Chilling And Storage Cycle
Prior to starting
•
the cycle:
CK640_ML_A5_v2_170425.indb 9
the device will switch to storage mode
the display will show the message "End"
the buzzer will sound for the period of time set by parameter AA
press any key to mute the buzzer; press once more to cancel the message
"End"
chilling will continue
the LED will flash and the LED
the buzzer will sound
press several times to:
- mute the buzzer
- display the time elapsed since the maximum chilling time expired
- display the cabinet temperature
- display the message "PoS"
- exit the procedure, or leave for 15 seconds
the device switches to storage mode
the LED will continue to flash and the LED
the display will show the message "End"
the buzzer will sound for the period of time set by parameter AA
press any key to mute the buzzer; press once more to cancel the message
"End"
the display shows the cabinet temperature
if chilling had a positive outcome, the LEDs
chilling had a negative outcome, the LEDs
LED will flash.
the parameter r9 sets the operational set point
press several times to:
- display the message "PoS"
- exit the procedure, or leave for 15 seconds
press for 2 seconds
A test is run in order to check correct pin probe insertion
- if the outcome of the test is positive, the cycle will be started
- if the outcome of the test is negative, the cycle will be started in timed
mode
will be on
will stay on
and will be on; if
and will be on and the
2017/4/25 13:23
UK
9