Polar CK640 Bedienungsanleitung Seite 7

Timed Positive Blast Chilling And Storage Cycle
To start the cycle: •
•
•
•
•
During chilling: •
•
•
•
•
Once the chilling •
period has •
elapsed:
•
•
During storage: •
•
•
•
To interrupt the
•
cycle:
Timed Negative Chilling And Storage Cycle
To start the cycle: •
•
•
•
•
CK640_ML_A5_v2_170425.indb 7
ensure the device is in "stand-by" mode and no procedures are running
press to select "PoS" and ensure the LED
press within 15 seconds: the display will show the duration of the blast
chilling step (in minutes)
press or within 15 seconds to change the value (the setting
remains active until another cycle is selected, when the value assigned by
parameter r1 is restored)
press : after 2 minutes, the appliance will run timed positive blast
chilling and storage cycle
the display shows the residual chilling time remaining
the LED is on
parameter r1 sets the chilling time duration
parameter r7 sets the operational set point
press several times to:
- display the message "PoS"
- display the cabinet temperature
- exit the procedure, or leave for 15 seconds
the device switches to storage mode
the display shows the message "End"
the buzzer sounds for the period of time set by parameter AA
press any key to mute the buzzer; press once more to cancel the message
"End"
the display shows the cabinet temperature
the LEDs and are on
the parameter r9 sets the operational set point
press several times to:
- display the message "PoS"
- exit the procedure, or leave for 15 seconds.
press for 2 seconds
ensure the device is in "stand-by" mode and no procedures are running
press to select "nEg" and ensure the LED
press within 15 seconds: the display will show the duration of the blast
chilling step (in minutes)
press or within 15 seconds to change the value (the setting
remains active until another cycle is selected, when the value assigned by
parameter r2 is restored)
press : after 2 minutes, the appliance will run timed negative chilling
and storage cycle
UK
is flashing
is flashing
7
2017/4/25 13:23