Ritter ESM 50 Gebrauchs- Und Montageanleitung Seite 16

English
GENERAL SAFETY
INSTRUCTIONS
To avoid personal injury or
damage to the appliance, please
observe the following safety
instructions:
– The hand blender is to be
used for domestic purposes
only and must not be used
commercially.
– Assembly (see page 16) must
be performed by qualified per-
sonnel only. ritterwerk will not
be held liable for the conse-
quences of improper or incor-
rect assembly.
– Do not start using the hand
blender until it has been
assembled by a professional.
– The power cord must be
routed in such a way that it
is not pinched and can run
directly and without obstruc-
tion from the build-in system
to the socket, which must be
mounted in the floor unit.
– Route the power cord so that
it does not come into con-
tact with hot or sharp-edged
objects. Do not bend it or wind
it around the appliance. Do not
allow the power cord to hang
down over the edge of the
worktop.
10
– The hand blender's motor
unit (2), the charging sta-
tion (13) and the plug-in power
supply (15) must not come into
contact with heat, fire, mois-
ture or dirt.
– The blender shaft (3) must not
come into contact with heat,
fire or dirt.
– Only connect the plug-in
power supply to a suitable AC
power source that complies
with the specifications on the
type label.
– Only use the charging sta-
tion, plug-in power supply and
accessories supplied with the
blender. The appliance must
only be operated using its orig-
inal parts and accessories.
– This appliance must not be
used by children. Keep the
appliance and its connection
cable out of reach of children.
– Persons with reduced phys-
ical, sensory or intellectual
capabilities or lacking in
relevant experience and/or
knowledge may only use this
appliance if they do so under
supervision or have been
instructed in the safe use of
the appliance and understand
the potential risks associated
with its use.