Operation; Technical Data - Facom E.2015 Original Bedienungsanleitung

OPERATION

Proper Hand Position
.
Proper hand position requires one hand holding the tool as Proper hand position requires one hand holding the tool as
shown in Figure 2.
Prior to operation
.
1. Attach the correct accessory recommended for the application.
2. Turn the air temperature adjustment knob (d ) to desired air temperature.
Switching On and Off (fi g. 4)
Push the on/off switch (a) to the desired air flow settings:
250 liter/min (50˚–400˚C)
I :
A low air flow to heat up the workpiece slowly.
500 liter/min (50˚–600˚C)
II :
A high air flow to heat up the workpiece quickly.
2. To turn the tool off, push the on/off switch (a) to position O. Disconnect the tool from the power source and let
the tool cool down before moving or storing it.
Removing Paint
.
1. Attach the appropriate accessory.
2. Turn the air temperature adjustment knob (d) to high.
3. Turn the tool on by selecting the desired air flow.
4. Direct the hot air onto the paint to be removed.
Best results will be achieved if the heat gun is moved slowly, but CONSTANTLY, from side to side to evenly
distribute heat. DO NOT LINGER OR PAUSE IN ONE SPOT.
5. When the paint softens, scrape the paint away using a hand scraper.
Stationary Use (fi g. 1)
.
This tool can also be used in stationary mode.
1. Fold down the kickstand (c) as shown in Figure 1.
2. Set the tool onto a level, stable workbench. Ensure the tool will not tip over.
3. Secure the power cord to prevent entanglement or pulling the tool off the workbench.
4. Turn the tool on by selecting the desired air flow.
Constant Heat Control (Overload Protection)
.
When the tool is overloaded, this feature protects the heating element from damage without stopping the tool
and/or without a cool down period.
1. When the temperature gets too hot, the heating element switches itself off. The motor will continue to run and
produce cold air.
2. When the temperature has cooled sufficiently (taking only a few seconds) the heating element will switch on
automatically.
Tool Ring (fi g. 1)
.
WARNING: ALWAYS turn heat gun off, disconnect from the power source and let the tool cool down for
at least 30 minutes before moving or storing it.
For easy storage, the tool can hang from the tool ring (f). The heat gun should be stored indoors.

TECHNICAL DATA

Model Power
input
E.2015 2000
Model Air temperature range setting 1
E.2015 50-400
NU-E.2015_0216.indd 8
Noise level
Pressure dB(A) Power dB(A)
''
k*
68 3 79
Air temperature range setting 2
°C
2
Vibrations
level
* k = measurement uncertainly in dB
m/s
2
** k = measurement uncertainly in m/s²
k* k**
3 0,86 1,5
°C
50-600
3
4
Weight Dimensions
kg cm
0,98 25 X 7,2 X 21
2/19/2016 3:07:33 PM